beautypg.com

Connecting/ adjusting the headset, Setting the dialing mode – Radio Shack HandsfreePhone withCallerID/CallWaiting User Manual

Page 8

background image

8

Preparation

RadioShack store. Or, you can let
the telephone company update
the wiring for you.

The USOC number of the jack to
be installed is RJ11C, or RJ11W
for a wall plate jack.

Plug one end of the supplied
short modular cord into the

TEL

jack on the top of the phone. Then
plug the other end into the wall
plate jack.

CONNECTING/
ADJUSTING THE
HEADSET

Connect the headset’s plug into

on the bottom of the phone.

Then follow these steps to adjust
the headset.

1. Place the headset on your

head with the earpiece over
either ear.

2. Adjust the headset band until

it rests with almost no pres-
sure on your ear and the top
of your head.

3. If the headset is loose, adjust

it inward slightly to tighten it. If
the headset is tight, gently
pull the headset band out to
loosen it.

4. Hold the headset in place,

and adjust the microphone
boom until it is about even
with your chin. Experiment
until you find the most com-
fortable position.

Caution: The microphone boom
swivels on the headset. Do not
bend the microphone boom while
you adjust it.

SETTING THE
DIALING MODE

Set

PULSE/TONE

on the top of the

phone for the type of service you
have. If you are not sure which
type you have, do this test.

1. Set

PULSE/TONE

to

TONE

.

2. Put on the headset and adjust

it as needed.

3. Press

TALK

and listen for a

dial tone.

4. Press any number other than

0

.

Note: If your phone system
requires that you dial an
access code (9, for example)
before you dial an outside
number, do not dial the
access code either.

If the dial tone stops, you
have touch-tone service.