Radio Shack HandsfreePhone withCallerID/CallWaiting - Manual (Page 10)

10 Phone Operation
To answer a call, press TALK .
TALK appears. To end a call,
press TALK again.
ADJUSTING THE
VOLUME
To adjust the volume of the sound
you hear through the headset dur-
ing a call, slide
VOLUME on the
side of the phone until you obtain
the desired volume level.
USING REDIAL
You can quickly dial the last num-
ber you dialed. Press
TALK , listen
for the dial tone, then press
REDIAL/PAUSE .
The redial memory can also store
tone entries (see “Using Tone
Services on a Pulse Line” on
Page 11) and pause entries (see
“Entering a Pause”).
ENTERING A PAUSE
In some telephone systems, you
must dial an access code (9, for
example) and wait for a second
dial tone before you can dial an
outside number. You should also
store a pause after the access
code to allow the outside line time
to connect when you redial the
number. To enter a 2-second
pause, press REDIAL/PAUSE . Re-
peatedly press REDIAL/PAUSE for a
longer pause.
Note: – appears when you press
PAUSE .
USING FLASH
Flash performs the electronic
equivalent of a switchhook opera-
tion for special services, such as
Call Waiting.
For example, if you have Call
Waiting, press
CALL BACK/FLASH
to answer an incoming call with-
out disconnecting the current call.
Press
CALL BACK/FLASH again to
return to the first call.
Note: If you do not have any spe-
cial phone services, pressing
CALL BACK/FLASH might discon-
nect the current call.
USING MUTE
Press MUTE to talk to someone
else in the room without the per-
son on the other end of the phone
line hearing your conversation.
MUTE appears. Press MUTE again
to resume your phone conversa-
tion.