Radio Shack ET-3504 User Manual

Page 11

Operation

• Press

to enter a space between

names.

• If you are using two consecutive let-

ters that reside in the same number
key, press

FUNC

between the letters.

For example, for “Tammy Smith,”
enter

8 2 6 FUNC 6 999 1 7777 6 444 8

5. Press

MEM

again.

;DJ;Hý J;Bý DKC8;H

appears.

6. Dial the desired number (up to 24 dig-

its).

7. Press

MEM

again to store the number.

The handset sounds two long beeps.

Note: If you hear three short beeps, you
did not store the number successfully.
Start again from Step 1.

8. Write down the stored name and num-

ber on the memory index sticker pro-
vided.

Notes:

• If the low battery warning tone

sounds, recharge or replace the bat-
tery within two minutes, or the num-
bers stored in memory will be lost.

• If you receive a call while you are

storing a number in memory, press
TALK to answer the call. After the
call, begin at Step 1 to store a num-
ber.

• To change a number stored in mem-

ory, simply store a new number in that
memory location.

Entering a Pause in a Memory
Number

In some telephone systems, you must dial an
access code (9, for example) and wait for a

second dial tone before you can dial an out-
side number. You can store the access code
with the phone number. However, if you do,
you should also store a pause after the ac-
cess code to allow the outside line time to
connect. After entering the access code,
press

REDIAL

to enter a 2-second pause.

Dialing a Stored Number

Press

TALK

. When you hear the dial tone,

press

MEM

then the memory location number

(

1–0

). The memory location number appears

and the phone dials the number.

To pre-dial a stored number, press

MEM

then

VOL/CID

to find the desired number,

then press

REDIAL/CALL BACK

Reviewing Stored Numbers

Press

MEM

. Enter the desired memory loca-

tion number (

, and so on), or press

VOL/CID

to scroll through the mem-

ory locations.

Deleting a Stored Number

1. Make sure the CHARGE/IN USE/MES-

SAGE indicator is not lit.

2. Press

MEM

then enter the memory loca-

tion number of the number to be
deleted, press

VOL/CID

select the memory location.

3. Press

FLASH/DELETE

;H7I;ý C;CE5

appears.

4. Press

FLASH/DELETE

again to clear the

memory. Two long beeps sound to con-
firm the number is deleted.

Or, press any other button to cancel the
deletion. Three short beeps sound.