RedMax G3100T - Manual (Page 28)

28
8. Operation
English
■ FUELING THE UNIT (F8-1)
1. Remove the fuel tank cap and pour fuel into the tank
up to 80% of full capacity.
2. Fasten the fuel cap securely and wipe up any fuel
spillage around the unit.
3. Remove the oil tank cap and pour chain oil into the
tank. Fasten the cap securely.
(1) Fuel
(2) Chain oil
1. Select bare ground for fueling.
2. Move at least 10 feet (3 meters) away from the
fueling point before starting the engine.
3. Stop the engine before refueling the unit.
It is very dangerous to run a chainsaw that mounts
broken parts or lacks any parts.
Before starting engine, make sure that all the parts
including bar and chain are installed properly.
■ STARTING ENGINE
Keep clear of the saw chain as it will start rotating
upon starting of engine.
1. Continuously push the priming bulb until fuel comes
in the bulb. (F8-2)
2. Put the ignition switch to “ I ” position. (F8-2)
3. While holding the throttle lever together with the
throttle interlock, push in the side button and release
the throttle lever to hold it at the start position. (F8-3)
4. Pull out the choke knob to the closed position. (F8-
4)
(1) Primer bulb (2) Ignition switch
(3) RUN (4) STOP
(5) Throttle interlock (6) Side button
(7) Thtottle lever (8) Choke knob
(9) OPEN (10) CLOSE
WARNING
WARNING
WARNING
F8-1
F8-2
F8-3
F8-4