3 mounting the display head – Raymarine Autohelm ST 30 User Manual
Page 16
Chapter 2: Installation
13
2.3 Mounting the Display Head
D682a
2
4
1
3
5
6
1 Display head 2 Sealing gasket 3 Fixing studs 4 SeaTalk or power cable
5 Fluxgate compass cable 6 Thumb nuts
1. Make sure the bulkhead to which the display head (1) is to be mounted
is smooth, flat, and clean.
2. Use the fitting template (supplied) to mark the centres for the two
fixing studs and the display head cable boss.
Please note...
To allow for the fitting of protective covers, adjacent instruments
must have a 6mm (1/4in) gap between them (116mm centre to
centre min.).
3. Drill two 5mm (0.2in) diameter holes for the fixing studs (2).
4. Using a 60mm (2.375in) diameter cutter, drill a location hole for the
instrument connector boss.
5. Plug the moulded end of the power cable in to one of the SeaTalk
terminals.
- RAYTHEON E32001 (13 pages)
- RAYCHART 420 (101 pages)
- L365 (83 pages)
- SR50 (48 pages)
- A65 (100 pages)
- RS12 (50 pages)
- DSM300 (82 pages)
- NMEA Multiplexer (16 pages)
- Pathfinder (111 pages)
- Pathfinder Radar (244 pages)
- autopilot control unit (111 pages)
- VolvoPenta IPS Autopilot System DPU (16 pages)
- autopilot + ST4000+ (145 pages)
- stand-alone master instrument (45 pages)
- ST80 (15 pages)
- Raystar 125 (8 pages)
- RS12 (38 pages)
- ST6001 (48 pages)
- Pathfinder Radar Scanners (66 pages)
- Chartplotter (101 pages)
- Heading Sensor (24 pages)
- Ray430 (54 pages)
- Viewable Marine Displays (38 pages)
- Marine GPS System (188 pages)
- C Series (244 pages)
- ST8001 (48 pages)
- hsb2 PLUS Series (246 pages)
- 631 PLUS (170 pages)
- navigation system (17 pages)
- ST8002 (48 pages)
- PowerPilot (18 pages)
- ST7002 (52 pages)
- GPS Kit (24 pages)
- 465 (107 pages)
- Ray54E (116 pages)
- GPS Plotter (131 pages)
- GPS navigation (75 pages)
- ST7001 (48 pages)
- 300 (136 pages)
- Raystar 120 (30 pages)
- autopilot (137 pages)
- DSM30 (34 pages)
- Platinum Chart Card (29 pages)
- ST6002 (56 pages)
- 320 (139 pages)