Radio Shack ET-549 - Manual (Page 14)

14
PAGING
To page the person who has the hand-
set or to locate the handset when the
phone is not in use, press
PAGE on the
base. The handset beeps five times.
MEMORY DIALING
You can store up to 10 numbers in
memory, then dial a stored number by
pressing a one-digit memory location
number.
Note: Each number you store can be
up to 16 digits long.
Storing a Number in Memory
Note: An error tone sounds and the
phone exits the programming mode if
you wait more than 20 seconds be-
tween each key press.
1. Lift the handset. If you hear a
tone, press TALK to turn it off.
2. Press MEMO . The BATT LOW
indicator blinks.
3. Enter the number and any TONE
and PAUSE entries (see “Using
Tone Services on a Pulse Line” on
Page 13 and “Entering a Pause”
on Page 15).
Note: Each TONE or PAUSE entry
uses one digit of memory.
4. Press MEMO , then enter the mem-
ory location number ( 0 - 9 ). A single
tone sounds to indicate that the
number is stored.
Note: If five quick beeps sound,
you have made an entry error and
the number was not stored. Start
again from Step 2.
43-1036.fm Page 14 Tuesday, August 17, 1999 9:52 AM