RCA 20F524T - Manual (Page 16)

_12
analog channel
entry
012-1_ _
Digital channel
entry
SETUP
Go back
Auto Channel Search
List & Labels
Closed Caption
Favorite Channel
Language
Eng.
Format Normal
Auto Vol. Level Off
AUTO CHANNEL SEARCH
Go back
Source Type
Cable
Start Search
Complete the Initial Setup
To set the language, use the arrow buttons to highlight Language. The default
language is English. To choose another language, press the right arrow button
on the remote, choose the language.
auto Channel Search
Auto Channel Search is located from this path Main Menu/Setup/Auto Channel
Search. It allows the TV to search for all channels available through your
ANTENNA/CABLE INPUT jack. This is sometimes called auto programming.
1. From the Auto Channel Search menu press the right arrow button to choose
the Source Type (Cable or Antenna). The default is Cable.
2. With the Signal Source chosen, highlight Start Search and press OK. Auto
Channel Search runs as it finds all the available channels. (This step might
take 10-15 minutes depending on your content provider). The channel
search finds both analog and digital channels.
3. Once the search is complete, your TV tunes to a channel. For information
on customizing your channels or menu options, go to Chapter 3.
Tuning to a Channel
The DIG•ANA button toggles between analog and digital channels. Analog
channels display in a rectangle as you enter the numbers. In the example to
the left, you can enter 12 or 012 to get the same channel. To enter a one-digit
channel, such as channel 8, just press 8. After entering the channel, press OK.
The CLEAR button on the remote clears all entries.
Digital channels can have both primary channels (like the analog channel
number) and subchannels. Digital channel numbers can contain up to six
numbers. Numbers to the left of the - (dash) are the main channel number;
numbers to the right are the subchannel numbers for stations that broadcast
more than one signal.
In the example, press “1”, then press “2” (although 012 is shown in the example,
pressing “0” isn’t required). Now press the right arrow button to move to the
subchannel. Press “1” and then “OK.” Your product tunes to channel 12-1. If
channel 12 is broadcasting subchannel signals, you would enter numbers that
access the other signals. (Example: 12-1, 12-2, 12-3). If the selection times out,
you must start over.
Notes: You may experience a delay of several seconds before digital
channels appear. This is normal. Digital channels sometimes take longer
to tune.
To see if you’re tuned to a digital or analog channel, press the INFO
button. This brings up the Channel Banner screen, discussed on page 18.
If the Channel Search brings up unavailable or blank channels, you might want
to get rid of these so they don’t appear as you change channels. To do this go
to Main Menu/Setup Menu/List & Labels. Removing channels from your channel
list may be time consuming, so you might want to do it later. Go to page 25 for
details on editing your channel list.
SETUP
Go back
Auto Channel Search
List & Labels
Closed Caption
Favorite Channel
Language
Eng.
Format Normal
Auto Vol. Level Off
Connections & Setup
1 Chapter 1