Regency P33 SunriseTM P33S-LP4 - Manual (Page 35)

Regency P33 Sunrise TM Gas Fireplace 35
INST
ALLA
TION
INSTALLATION
OPTIONAL STAINLESS STEEL
REFLECTIVE PANEL INSTALLATION
1) If already installed, remove the burner assembly and fi rebox base
(See page 43 for instructions).
2) Remove 4 screws prior to top panel installation.
Diagram 2
Diagram 3
Back Panel
Diagram 4
Diagram 1
Diagram 5
Diagram 6
Diagram 8
3) Place the top Stainless panel in fi rst, secure with 4 screws.
(See Diagram 1 for screw locations)
5) With the top panel in place - install back panel. The back panel fi ts
under the top panel, push the top panel up to fi t back panel into
position. (Diagrams 3 & 4)
6) The side panels are installed last, slide in as shown in Diagram 6.
Note: The bend in the metal on the side panels should face outward
(toward inside of fi rebox - see Diagram 5).
If the side panels have been installed incorrectly the fi rebox base will
not fi t.
7) Reinstall the fi rebox base and burner assembly.
Before you start :
Stainless panels must be inspected for scratches and dimples prior to installation. All claims to be recorded at this time. Claims for damage
after installation will not receive consideration.
To protect the fi nish during installation and handling - cotton gloves MUST be worn at all times while handling the panels (even when
removing protective coating).
Stainless panels will discolor a little during normal operation. This is normal and should not be considered a defect.
* All hand and fi nger marks MUST be cleaned off with a soft cloth and a stainless steel cleaner. Most stainless steel cleaners leave a fi lm/
residue on the surface of the panels. Use an ammonia based cleaner (ie. glass cleaner) to remove this fi lm before applying heat to the unit.
Failure to do this will result in burn stain on panels which you will be unable to remove.
This is not a warranty item.