Radio Shack Race Scanner - Manual (Page 27)

27
Notes:
• To step through the frequencies while HOLD is displayed, press
t or s.
• If you tune to a search skip frequency, L/O appears (see
“Search Skip Memory” on Page 27).
• To store a frequency into a channel while the frequency is
paused or held, see “Storing Active Frequencies.”
Storing Active Frequencies
To store an active frequency into a channel, press PROG while the fre-
quency is paused or held. The lowest available channel number flash-
es.
• To enter the frequency into that channel, press E .
• To change the channel, enter the desired channel number, then
press PROG .
The frequency currently stored in that channel (if any) appears for
about 2 seconds, then the new frequency appears. Press
E to store the
new frequency.
Notes:
• If you previously stored a car number and frequency in a channel
(see “Storing a Car Number and Frequency” on Page 31), the
scanner clears the number and frequency when you store a new
frequency into that channel.
• If there are no empty channels, the channel number changes to 1
and FULL appears. To clear FULL from the display, press CLEAR .
SEARCH SKIP MEMORY
You can skip up to 20 specified frequencies during a service bank, di-
rect, or weather search. This lets you avoid unwanted frequencies or
ones you have already stored in a channel. You can specify all 20 fre-
quencies to be skipped during one type of search (direct search, for ex-
ample), or you can divide the frequencies you skip among two or all
three search types.
20-513.fm Page 27 Wednesday, August 4, 1999 2:39 PM