RCA Model 21011 - Manual (Page 40)

40
S
TORING A
R
EDIAL
N
UMBER
1. Make sure the phone is OFF (not in TALK mode).
2. Press the DIR soft key.
3. Press any number key (01-50) to store the phone number in that
memory location, or press the cid/vol (up and down arrow) button on
the handset or CID (up and down arrow) button on the base to select the
memory location.
4. Press the EDIT soft key and ENTER NAME shows in the display.
5. Use the touch tone pad on your handset or base to enter the name, then
press the OK soft key and ENTER TEL NUMBR shows in the display.
6. Press the redial button to display the redial number.
7. Press the OK soft key again to confirm.
NOTE: If the redial number has more than an 24 digits, the redial number
cannot be stored in memory.
I
NSERTING A
P
AUSE IN THE
D
IALING
S
EQUENCE
If a pause is needed to wait for a dial tone press the # pause button on
the number pad to insert a delay in dialing sequence of a stored
telephone number (for example, after you dial 9 for an outside line, or
wait for a computer access tone.) Each pause counts as one digit in the
dialing sequence.
R
EVIEWING
, C
HANGING OR
D
ELETING
S
TORED
N
UMBERS
T
O
R
EVIEW
:
1. Make sure the phone is OFF (not in TALK mode).
2. Press DIR soft key.
HANDSET 1
DIR MENU
NAME