RIDGID 13 in. THICKNESS PLANER R4330 - Manual (Page 16)

16
ASSEMbLY
LEVELING THE TAbLE ExTENSIONS
See Figure 9.
The infeed and outfeed table extensions are attached to
the planer. Shipped in a folded, upright position, the table
extensions must be in the down position before planing can
begin. For accurate planing, table extensions must be level
with the planer table.
NOTE: For optimum performance, always check to make
sure the table extensions are level before beginning planing
operations.

Place a straight edge or level across both the planer table
and table extensions.
 If adjustment is necessary, lift table extensions and loosen
lock nuts. Adjust stop screws (one on each side) until
extension table is level with planer table.
 Press down on the table extension to ensure the table
extension is properly seated.
 Tighten lock nuts securely when adjustments are
complete.
loCk nut
StoP
SCrewS
tABle
extenSion
PlAner
tABle
StrAiGht
edGe
tABle
extenSion
Fig. 9