Radio Shack ET-1125 - Manual (Page 9)

9
2. Lift the battery pack out of the com-
partment.
3. Plug the battery pack’s connector in-
to the socket in the compartment,
(the connector fits only one way), re-
place the battery pack, and replace
the cover.
To charge the battery pack, place the
handset either faceup or facedown on
the base. The CHARGE/IN USE indica-
tor on the base lights and
Total:00
appears on the handset display.
Recharge the battery pack when Low
Battery flashes on the display.
Note: If the CHARGE/IN USE indicator
flashes when the handset is on the
base, the battery pack is not connected
or loosely connected. Reconnect the
battery pack securely.
Notes:
• When you first use the phone after
charging or recharging the battery
pack, the phone might not work and
you might hear an error tone when
you press
TALK . Return the handset
to the base for about 5 seconds to
reset the security access-protection
code.
• If the handset or the base loses
power, the security access-protec-
tion code might be lost. To reset the
code, return the handset to the base
for about 5 seconds.
• Using a pencil eraser, clean the
charging contacts on the handset
and base about once a month.
• If the battery pack becomes weak
during a call, the handset beeps ev-
ery 3 seconds and
Low Battery
flashes. When this happens, you
cannot make a call until you re-
charge the battery pack.
• About once a month, fully discharge
the battery by keeping the handset
off the base until
Low Battery
flashes on the display. Otherwise,
the battery pack loses its ability to
fully recharge.