Radio Shack ET-1125 - Manual (Page 7)

7
3. Route the adapter’s cord through
the strain relief slot on the base.
4. Plug the modular cord’s other end
into the phone jack.
5. Plug the adapter into a standard AC
outlet.
6. Lift the base’s antenna to a vertical
position.
On a Wall Plate or Wall
1. Plug one end of the supplied short
modular cord into the TEL LINE jack
on the back of the base as in “On a
Desk, Shelf, or Table,” Step 1, on
Page 6.
2. Insert the supplied AC adapter’s
barrel plug into DC IN 9V as in “On a
Desk, Shelf, or Table,” Step 2, on
Page 6.
3. Route the adapter and modular
cords through the grooves on the
base.
4. Plug the modular cord’s other end
into the wall plate jack, then align
the base’s keyhole slots with the
wall plate studs and slide the base
downward to secure it.
5. Plug the adapter into a standard AC
outlet.
6. Press and lift out the handset hold-
er. Rotate it 180°, then snap it back
into place so it holds the handset.