Roberts Radio 63I - Manual (Page 66)

65
FM Radio
Operating your radio in FM mode
1. Carefully extend the telescopic aerial and press the On/Standby button to
switch on your radio.
2. Press the Radio button as needed to select FM radio mode.
3. Press the Menu Up button (on the radio) or the Right button (on the remote
control) and then the Auto button on the remote control. The displayed
frequency will increase. Your radio will scan up the FM band from the currently
displayed frequency and will stop scanning when it fi nds a station of suffi cient
strength.
4. The display will show the frequency of the signal which has been found. If
RDS information is available, after a few seconds the display will show the
radio station name.
If you only hear hiss or interference, simply press the Auto button to scan
further. Your radio may have found a spurious interference signal.
5. To fi nd more FM stations press the the Auto button (on the remote control)
to repeat the scan operation. To scan down in frequency, press the Menu
Down button (on the radio) or the Left button (on the remote control) and then
the Auto button. Your radio will scan down the FM band from the currently
displayed frequency and will stop scanning when it fi nds a signal of suffi cient
strength.
6. Alternatively press and hold the Menu Up on the radio to scan up in frequency
or the Menu Down button to scan down the FM band. Alternatively press
and hold the Left or Right buttons on the remote control.
7. When the end of the waveband is reached your radio will recommence tuning
from the opposite end of the waveband. Use the Volume buttons to adjust
the sound level as needed.
2
5,6 3-6
3-5
3-6 5,6