Regency C33-LP3 - Manual (Page 8)

8 Regency ® CLASSIC C33-3 Freestanding Gas Stove
INSTALLATION
PEDESTAL ASSEMBLY
1) For easier assembly, tip the stove on its back
(preferably onto a soft surface to prevent
scratching).
2) Unscrew the 4 bolts in the underside of the
stove. Align the holes in the corners of the
pedestal top with the corresponding holes in
the base of the stove. Use washers which
are supplied with the pedestal as shown in
diagram. Reinstall bolts.
Diagram 1
Wiring Diagram
Wiring
11) Remove the dummy plug from the right side
of the bottom shield or pedestal and install
the supplied fan switch.
12) Attach hot wire from power cord to the ther-
modisc.
13) Slide the thermodisc under the bracket.
16) Pull power wire back and put strain relief
grommet in place as per diagram 4.
17) Reverse steps 3-1 to complete installa-
tion.
Note: The #8 ground lug is a dedicated
ground for mobile home use only.
Only C34 unit is approved for mobile
homes.
Caution: Ensure that wires do
NOT touch hot surfaces.
Fan Removal
1) Disconnect the power to fan.
2) Allow the stove to cool to room tempera-
ture.
3) Open the pedestal door and remove the
screws on the door cover plate. Leg Units:
Remove bottom access panel.
4) Loosen the nutsert screws.
5) Remove Fan Assembly from the key slots
at the fan base. Take the fan out from the
rectangular opening . Diagram 3.
6) Turn the fan around 90 degrees (Pedestal
units only). Diagram 2.
7) Disconnect the green ground wires to the
grounding lug.
8) Disconnect the white wire of the fan from
the power cord.
9) Disconnect red wire and black wire (from
fan to Fan Switch).
10) Take fan out from the stove body. Diagram
14) Connecting wires to the 3 way switch -
a. Connect the red wire from the fan to the
top of the 3 way switch.
b. Connect black wire from fan to the bottom
of the 3 way switch.
c. Connect white jumper wire to middle of
the three way switch. See wiring diagram
below.
15) Connect white wire from fan motor to neutral
on the power cord.
View from Bottom of Stove
3) Hook up wires to Burner ON/OFF switch
and valve assembly (be careful not to pinch
wires). See Diagram 1.
4) Push the Regency ® logo into the two holes
in the front bottom left corner of the pedestal
cover plate.
Note: Any paint touch up should be done
prior to placing logo on pedestal.