Regency C33-LP3 - Manual (Page 16)

16 Regency ® CLASSIC C33-3 Freestanding Gas Stove
OPERATING INSTRUCTIONS
LIGHTING
PROCEDURE
NOTE: For all propane units and units
equipped with electric spark boxes,
see "Copy of Lighting Plate Instruc-
tions" section for more details.
IMPORTANT: Gas on/off knob cannot be
turned from "PILOT" to "OFF" unless it is
partially depressed.
1) Turn burner OFF using "ON/OFF" switch.
2) Turn gas control knob so indicator points
to "OFF" position and allow 5 minutes for
any gas in the combustion chamber to
escape.
3) Turn gas control knob counterclockwise
so indicator points to the "PILOT" position.
Depress the gas control knob fully. Depress
the igniter button several times until the
pilot lights. After approximately one minute,
release the gas control knob. The pilot fl ame
should continue to burn. If the pilot does not
remain lit, repeat operation allowing a longer
period before releasing gas control knob.
4) When the pilot stays lit, turn the gas knob
further counterclockwise to the "ON" posi-
tion.
5) Use the ON/OFF switch, wall switch, thermo-
stat or remote control to turn on the unit.
6) Rotate the fl ame height regulator (Hi/Lo) to
adjust the fl ame height higher or lower.
SHUTDOWN
PROCEDURE
1) Use the "ON/OFF" switch, wall switch,
thermostat or remote control to turn off the
burner.
2) Push in the PILOT knob slightly and turn
clockwise to "OFF". Do not force.
3) Turn off all electric power to the appliance
if service is to be performed.
OPERATING
INSTRUCTIONS
1) The FIRST FIRE in your stove is part of the
paint curing process. To ensure that the paint
is properly cured, it is recommended that
you burn your fi replace for at least four (4)
hours the fi rst time you use it with the fan
on. When fi rst operated, the unit will release
an odour caused by the curing of the paint
and the burning off of any oils remaining
from manufacturing. Smoke detectors in
the house may go off at this time. Open
a few windows to ventilate the room for a
couple of hours. The glass panel may require
cleaning.
Do Not Attempt To Clean The Glass While
it is still hot!
Note: When the glass is cold and the appli-
ance is lit, it may cause condensation
and fog the glass. This condensation
is normal and will disappear in a few
minutes as the glass heats up.
DO NOT BURN THE APPLIANCE
WITHOUT THE GLASS FRONT IN
PLACE.
2) Read and understand these instructions
before operating this appliance.
3) Check to see that all wiring is correct and
enclosed to prevent possible shock.
4) Check to ensure there are no gas leaks.
5) Make sure the glass in the door frame is
properly positioned. Never operate the ap-
pliance with the glass removed.
6) Verify that the venting is unobstructed.
7) Verify log placement. If the pilot cannot be
seen when lighting the unit - the logs have
been incorrectly positioned.
8) The unit should never be turned off, and on
again without a minimum of a 60 second
wait for purging.
MAINTENANCE
INSTRUCTIONS
1) Always turn off the gas valve before cleaning.
For relighting, refer to lighting instructions.
Keep the burner and control compartment
clean by brushing and vacuuming at least
once a year.
When cleaning the logs, use a soft clean
brush as the logs are fragile and easily
damaged.
2) Clean appliance and door with a damp
cloth (never when unit is hot). Never use
an abrasive cleaner. The glass should be
cleaned with a gas fi replace glass cleaner
(when it starts to cloud up).
3) The heater is fi nished in a heat resistant
paint and should only be refi nished with
heat resistant paint. Regency
® uses Stove
Brite Paint - Metallic Black #6309.
4) Make a periodic check of burner for proper
position and condition. Visually check the
fl ame of the burner periodically, making sure
the fl ames are steady; not lifting or fl oating.
If there is a problem, call a qualifi ed service
person.
5) The appliance and venting system must be
inspected before use, and at least annually,
by a qualifi ed fi eld service person, to ensure
that the fl ow of combustion and ventilation
air is not obstructed.
During the annual service call, the burners
should be removed from the burner tray
and cleaned. Replace the embers and rock
wool.
6) Each time the appliance is lit, it may cause
condensation and fog the glass. This con-
densation is normal and will disappear in
a few minutes as the glass heats up.
7) Caution: Label all wires prior to discon-
nection when servicing controls. Wiring
errors can cause improper and dangerous
operation. Verify proper operation after
servicing.
WARNING: CHILDREN AND
ADULTS SHOULD BE ALERTED
TO THE HAZARDS OF HIGH
SURFACE TEMPERATURES AND
SHOULD STAY AWAY TO AVOID
BURNS OR CLOTHING IGNITION.
YOUNG CHILDREN SHOULD BE
CAREFULLY SUPERVISED WHEN
THEY ARE IN THE SAME ROOM
AS THE APPLIANCE.