Regency C33-LP3 - Manual (Page 19)

Regency ® CLASSIC C33-3 Freestanding Gas Stove 19
7) Install the replacement glass. When placing
the replacement glass in the door, make
sure that the glass gasketing will properly
seal your unit.
8) Put glass in place and then position glass
retainer rod.
Note: Do not use substitute materials. If
your glass does break, do not con-
tinue to use your unit until it has been
replaced.
9) Position the glass retainer clips and door
securing bracket. Secure the glass retaining
screws but do not overtighten as this may
cause the glass to break after the unit heats
up.
10) Tighten all screws evenly.
Note: Do not overtighten as this may cause
breakage.
11) Slip door over hinge pins.
12) Put hinge caps back onto door.
13) Close door and secure the security bracket
with the screw.
GLASS
REPLACEMENT
Your CLASSIC stove is supplied with high
temperature, 5 mm Neoceram ceramic glass
that will withstand the highest heat that your
unit will produce. In the event that you break
your glass by impact, purchase your replace-
ment glass from an authorized Regency
® dealer
only, and follow our step-by-step instructions
for replacement.
1) Allow the stove to cool before removing or
replacing glass.
2) To remove the door from the stove remove
the securing screw located between the ash-
lip and the door, then unfasten the latch.
3) Remove gold hinge caps from door.
4) Lift door off hinge.
5) Lay door on a soft, fl at surface.
6) Remove the screws in the glass retainer
clips and remove the glass retainer rod.
Remove any remaining pieces of glass
and ensure that the door is free of debris.
Use caution when removing broken glass
to avoid injury.
MAINTENANCE
LOG REPLACEMENT
The unit should never be used with broken
logs. Turn off the gas valve and allow the unit
to cool before opening door to carefully remove
the logs. The pilot light generates enough heat
to burn someone.
If for any reason a log should need replace-
ment, use only Regency
® replacement logs.
The position of these logs must be as shown
in the diagram under Log Installation.
NOTE: Improper positioning of logs may
create carbon build-up and will alter
the unit’s performance which is not
covered under warranty.
GOLD-PLATED DOORS
The 24 carat gold plated fi nish on the door
requires little maintenance, and need only
be cleaned with a damp cloth. DO NOT use
abrasive materials or chemical cleaners, as
they may harm the fi nish and void the warranty.
Clean any fi ngerprints off before turning
the unit on.