Toshiba VTV21FL3 - Manual (Page 35)

33
ENGLISH
If you connect the TV/VCR to another VCR or VIDEO CAMERA, you can duplicate a previously recorded tape. Make
all connections before turning on the power.
CONNECTION TO CAMCORDER CONNECTION TO ANOTHER VCR
For duplicating a previously recorded tape from a camcorder,
follow the camcorder manufacturer’s instructions. A typical
camcorder dubbing hookup is shown below.
Playback
Camcorder
PLAY
Press both the REC/OTR
buttons at the same time on
the remote control of the
TV/VCR, then press the
PAUSE/STILL button. Press the PLAY Button on the
playback VCR, then press the
PAUSE/STILL button. Press the PAUSE/STILL
buttons on both units
simultaneously to begin the
duplicating process.
NOTE: Unauthorized recording of copyrighted television programs, films, video cassettes and other materials may
infringe the rights of copyright owners and be contrary to copyright laws.
Load a blank cassette tape with the erase
prevention tab intact into the recording VCR.
Load a previously recorded tape into the
playback VCR or VIDEO CAMERA. Press the AV button to select the AUDIO/VIDEO
input position. The "AV2" will appear on the
screen.
0 / AV
0
Playback VCR
Audio/Video Cord (not supplied)
To VIDEO
OUT
To AUDIO
OUT
To VIDEO IN To AUDIO
IN
To AV Jack
Audio/Video Cord
(not supplied)
To VIDEO/AUDIO IN
NOTE: You can also use the rear AUDIO/VIDEO IN
Jacks. Select "AV1" by pressing the AV
button.
AV 2
DUPLICATING A VIDEO TAPE
PAUSE/STILL
Recording TV/VCR
Recording TV/VCR
PAUSE/STILL REC OTR
5960101A/E/33-back 28/5/01, 12:37 PM 33