Ricoh A251 - Manual (Page 39)

31
SETTING A LEADING EDGE MARGIN
You can set a margin at the leading edge of the copy.
Notes
❐ You can set up to ±99mm, ±4.0” margin in 1mm, 0.1” steps at the leading edge.
❐ The copy image is shifted to the trailing edge, when you make a copy using the Copy paper table,
or in the Preset Cut mode, Variable Cut mode.
❐ In the Semi Synchro Cut mode, the paper extend by the leading margin width.
1 Press the Function Select key until the “Lead-
ing Edge” or “Trailing Edge” indicator is lit.
2 Press the + key and - key to specify a edge
margin.
To zero the value, press the Clear/Stop key.
3 Insert the original from the leading edge.
You can get same results using the Rear Table.
Paper Length
Semi Synchro
Preset/
Variable
Leading Edge
Copy Counter
Function Select RF Select /Cut
Cut Select
Preset Cut
Using the Copy Paper Table, or in the Preset Cut mode,
Variable cut mode In the Semi Synchro Cut mode
Leading Edge
Margin
Leading Edge Margin