beautypg.com

Changing the remote operation security code, Remote operation, Using the toll-saver – Radio Shack TAD-705 User Manual

Page 19: Using remote commands

background image

19

TAD Operation

CHANGING THE REMOTE
OPERATION SECURITY
CODE

The TAD's remote operation security code is
preset to 705, but you can change it by fol-
lowing these steps.

Note: If you do not complete each step with-
in 8 seconds, the TAD exits setup. Start
again from Step 1.

1. Hold down

STOP

until the TAD beeps

once.

2. Press

DIAL

three times.

705

and

SECURITY

CODE

appear.

7

flashes.

3. Repeatedly press

:

:

:

:

/

8

8

8

8

to set the first

digit, then press

9

9

9

9

/

;

;

;

;

. The second digit

flashes.

Note: If you make a mistake, repeatedly
press

9

9

9

9

/

;

;

;

;

to the position of the incor-

rect digit then re-enter the code.

Repeat Step 3 to set the second and the
third digits.

4. Press

DIAL

then press

STOP

to return to

the time display.

REMOTE OPERATION

You can operate the TAD from almost any
touch-tone phone, or from a rotary phone us-
ing a pocket tone-dialer (available at your lo-
cal RadioShack store).

USING THE TOLL-SAVER

If the ring select switch is set to TS (toll-sav-
er), the TAD answers after two rings if you
have new messages. If there are no new
messages, the TAD answers after four rings.
This gives you time to hang up before the
TAD answers so you can avoid unnecessary
long-distance charges. See “Setting the
Number of Rings” on Page 10.

USING REMOTE
COMMANDS

Follow these steps to operate the TAD re-
motely.

1. Dial your phone number.

2. When the TAD answers, enter your

remote operation security code. The
TAD beeps once to confirm that you
entered the correct code.

Notes:

• If you do not enter each digit within 8

seconds, the TAD hangs up.

• If the TAD is not set to answer calls, it

answers after about 9 rings.

3. Enter a remote command (see “Remote

Command List”).

4. When you finish, hang up.

Remote Command List

Press

To

00

Set the TAD to not answer calls. The TAD says “Answer off” then
beeps.

01

Set the TAD to answer calls. It beeps, says “Answer on,” plays OGM
1, then beeps. If no OGM 1 is recorded, it beeps and says “You have
no announcement one.”

43-705.fm Page 19 Tuesday, May 23, 2000 8:54 AM