Radio Shack TAD-705 - Manual (Page 14)

14 Telephone Operation
Dialing a Memory Number
To dial a number stored in memory, lift the
handset or press
HEADSET/SPEAKER-
PHONE , then press the desired memory loca-
tion button. Or you can press the desired
memory location button then press
DIAL .
Chain-Dialing
For quick recall of numbers for special ser-
vices (such as bank-by-phone or alternate
long-distance), you can store each group of
numbers in its own memory location. Then,
when calling special services, dial the ser-
vice's main number first. At the appropriate
place in the call, press the memory location
button for the additional numbers you want to
send.
Testing Stored Emergency Num-
bers
If you store an emergency service's number
(police department, fire department, ambu-
lance) and you want to test the stored num-
ber, make the test call during the late
evening or early morning hours to avoid peak
demand periods. Remain on the line to ex-
plain the reason for your call.
CONNECTING AN
OPTIONAL HEADSET
Your TAD is equipped with a headset jack on
the base. The jack allows you to connect an
optional headset so you move around within
the headset cord's length.
Follow these steps to use a headset:
1. Insert the headset's 3 /
32
-inch (2.5 mm)
plug into the jack on the right side of
the base.
2. Place the headset on your head with the
earpiece over either ear and adjust the
microphone boom until it is about even
with your chin.
3. Press HEADSET/SPEAKERPHONE to
make or receive calls. == HEADSET ==
displays.
4. When you finish the conversation, press
HEADSET/SPEAKERPHONE to hang up.
Note: You cannot use the speakerphone
with a headset connected to the TAD.
43-705.fm Page 14 Tuesday, May 23, 2000 8:54 AM