Radio Shack 43-3872 - Manual (Page 32)

Using Your Phone
32
ADJUSTING THE RINGER
,
EARPIECE AND SPEAKER
VOLUME
Ringer volume
In standby mode, repeatedly press on
the handset or base to select ringer
volumes. You can select from one of three
ringer volumes (Off, Low, or High) for the
handset, and one of four ringer volumes
(Off, Low, Medium, and High) for the base.
Earpiece and Speaker Volume
You can select earpiece volume from
among six volume levels on the handset
and the base. For speaker volume, select
from among six volume levels on the
handset and ten volume levels on the base.
Pressing the volume up key or volume down
key on the handset or base during a call will
change the earpiece or speaker volume.
This setting will remain in effect after the
telephone call has ended.
If you press the volume up key when the
earpiece is at the maximum volume level,
an error tone sounds.
The error tone also sounds if you press the
volume down key at the lowest volume.
Audio Tones (Base only)
The audio tone features provide three
different tone levels (Natural Tone, Hight
Tone, or Low Tone). If you have difficulty of
hearing a caller adjust audio tone level. The
default setting, Natural Tone, is
recommended for hearing aid users. Ô
1. While on a call, press the MENU soft
key.
2. Press to select Audio Tone
Setup , and then the OK soft key.
Ô
NOTE
Ô
The Audio Tone feature can
not be used while using
speaker phone.
43-3880.book Page 32 Monday, June 28, 2004 2:07 PM