Ryobi DP102L - Manual (Page 17)

16 17
CHECKING/ADJUSTING LASER ALIGNMENT
See Figure 15.
Check the laser alignment to ensure the intersection of the
laser lines is precisely at the spot where the drill bit meets
the workpiece. If it is not, the laser lines should be adjusted
using the laser adjustment knobs located on opposite sides
of the head assembly.
n
Mark an “X” on a piece of scrap wood.
n Insert a small drill bit into the chuck and align its tip to
the intersection of the lines of the “X”.
n Secure the board to the table.
n Turn on the laser and verify the laser lines align with the
“X” on the workpiece.
n If the laser lines do not align, loosen the set screws on
each of the laser housings with a hex key and rotate the
laser adjustment knobs until the lines meet in the center
of the “X”. Retighten the set screws to secure.
ASSEMBLY
Fig. 15
LASER
ADJUSTMENT
KNOB
LASER HOUSING
SET SCREW