Assembly – Ryobi DP102L User Manual
Page 15
14
15
ASSEMBLY
Fig. 9
Fig. 11
SCRAP
WOOD
CHUCK
HEAD
ASSEMBLY
SPINDLE
HEAD
ASSEMBLY
INSTALLING CHUCK, HEAD ASSEMBLY, AND
FEED HANDLES
See Figures 9 - 11.
n
Place the head assembly upside down on a level, flat
surface.
n
Position chuck on spindle. Chuck should be fully opened
to avoid damaging jaws.
n
Using a piece of scrap wood to protect the chuck, firmly
tap the chuck into place using a mallet or hammer.
n
Position the head assembly onto the column with the
chuck positioned over the table.
NOTE: This tool is heavy. Get help when needed.
n
Slide the head assembly down as far as it will go. Align
the table assembly with the base and then tighten the
two head set screws with the hex key.
n
Attach the three feed handles by screwing them into the
threaded holes in the hub.
INSTALLING/CHANGING WORKLIGHT BULB
See Figure 12.
The integrated worklight can be used to help illuminate
the work area. The worklight requires a 15-watt, 120-volt,
candelabra-base bulb (bulb not included).
To install, insert the bulb into the worklight receptacle and
twist clockwise to secure.
SET
SCREWS
FEED
HANDLE
BULB
Fig. 10
Fig. 12