3i f, Etting, Your – ResMed HumidAire 3i User Manual
Page 11: Umid

6
S
ETTING
U
P
YOUR
H
UMID
A
IRE
3i F
OR
U
SE
!
WARNING
Make sure your flow generator is switched off at the power outlet before
connecting the HumidAire 3i.
R
EMOVING
THE
FRONT
CAP
(
IF
FITTED
)
Please refer to the illustrations in section B of the illustration sheet.
Your flow generator may be fitted with a front cap (B-1). Before you can attach the
H
UMID
A
IRE
3i, press the button underneath the front cap (B-2) and pull it away from
the body of your flow generator (B-3 & B-4).
Notes
•
To replace the front cap, align it with your flow generator (B-4) and push it firmly until it
clicks into place.
•
Remember to take the front cap with you when travelling, in case you need CPAP
therapy without a humidifier.
R
EMOVING
AND
STORING
THE
CONNECTOR
PLUG
Please refer to the illustrations in section C of the illustration sheet.
Before attaching the H
UMID
A
IRE
3i, remove the connector plug from your flow
generator (C-1) and attach it to the back of the docking station (C-2).
A
TTACHING
YOUR
H
UMID
A
IRE
3i
Please refer to the illustrations in section D of the illustration sheet.
1
Align your H
UMID
A
IRE
3i with your flow generator (D-1) and push them together
until they click into place (D-2).
!
WARNING
•
The HumidAire 3i docking station should only be connected or disconnected
when the water chamber is empty.
•
Water must be prevented from entering your flow generator. Do not transport
the flow generator with the HumidAire 3i attached.
2
Insert the power cord into the socket at the rear of your flow generator. Plug the other
end of the power cord into a power outlet (D-3).
Note: If your flow generator is powered via the DC input, the HumidAire 3i is not powered
and humidification output will be reduced.
3
Place the combined unit on a firm, level surface near your bed at a level lower than
your sleeping position. Ensure the surface is not sensitive to heat and/or moisture, or
use a protective mat.
!
CAUTION
Be careful not to place the unit where it can be bumped into and knocked over.
338282r3.book Page 6 Friday, November 10, 2006 2:10 PM