ResMed VPAP AUTO 25 - Manual (Page 9)

6
How to Select the Mask Type
Scroll to MASK and select . Press or until you see the setting you
require. The following table shows the setting that should be selected for each mask:
How to change the EPR level (CPAP mode)
Expiratory Pressure Relief (EPR) can be used to improve your comfort level when
breathing out during treatment. If patient access is enabled by the clinician you can
change the EPR level. There are four settings: OFF; 1 (lowest EPR); 2; and 3 (highest
EPR).
1
On the standby (RAMP) screen, press .
2
Press until you see EPR LEVEL, then press .
3
Press or until you see the setting that you require.
4
Press to save the setting.
How to change the Exhalation rate (VAuto mode)
If patient access is enabled by the clinician, you can adjust the Exhalation rate so that
the rate of pressure drop is at a level that is most comfortable for you. There are three
settings: Fast; Medium; and Slow.
1
On the standby (SETTLE) screen, press .
2
Press until you see EXHALATION, then press .
3
Press or until you see the setting that you require.
4
Press to save the setting.
SmartStart™
If your clinician has enabled SmartStart/Stop, your device will start automatically
when you breathe into your mask and stop automatically when you take your mask
off.
Settings Mask
ULTRA Ultra Mirage Nasal Mask
Ultra Mirage II Nasal Mask
MIR FULL Mirage Liberty Full Face Mask
Mirage Quattro Full Face Mask
Ultra Mirage Full Face Mask
ACTIVA Mirage Activa Nasal Mask
SWIFT Mirage Swift Nasal Pillows System
Mirage Swift II Nasal Pillows System
Swift LT Nasal Pillows System
STANDARD Mirage Vista Nasal Mask
Mirage Micro Nasal Mask
MIRAGE Mirage Nasal Mask