ResMed VPAP AUTO 25 - Manual (Page 10)

7 Using the VPAP Auto 25, VPAP ST & VPAP S
En
gli
sh
Starting Treatment
1 Make sure the power is on.
The product name is displayed briefly on the LCD screen, then the standby (Ramp/
Settle) screen appears. The key and LCD backlights also turn on.
2 Fit your mask as described in the mask user instructions.
!
WARNING
A mask should not be used unless your VPAP device is turned on and operating
properly.
3 Alter the ramping/settling time if required.
4 To start therapy, simply breathe into the mask or press .
5 Lie down and arrange the air tubing so that it is free to move if you turn in your sleep.
6 After starting therapy an introductory screen will display:
Stopping Treatment
To stop treatment at any time, remove your mask and press . If your clinician
has enabled SmartStart/Stop, simply remove your mask and treatment will end.
Note: SmartStart/Stop will not work if:
• you have a Full Face Mask; or
• your clinician has enabled Leak Alert.
LK: 10L/min RR: 15
MV: 10.2 VT: 680
S:RAMP 4.0-10.0
>>>> PS 6.0
S**TiMn TiMx 2.0
Ti 1.5s 1: 1.6
SpO2: 98%
HR : 60 exit This screen only displays if
ResLink and an oximeter are
connected
Inspiration information
Leak and breath information
Mode and pressure display S mode
example