Renesas H8S/2338 Series - Manual (Page 22)

16
4. In the H8S/2338 series MCU, the interrupt signal pins can be selected by the register setting. To
trace the interrupt signals in the E6000 emulator, select the interrupt signal pins by setting switch
P5 on the user system interface cable as shown in table 2.
Table 2 Switch P5 Setting
IRPAS Bit Value Interrupt Signal Pin Pin No. P5 Setting
IRQ4 40
0 IRQ5 34 Close between 2 and 3
(Initial value) IRQ6 33 (setting at shipment)
IRQ7 32
IRQ4 105
1 IRQ5 106 Close between 1 and 2
IRQ6 107
IRQ7 108
5. In the H8S/2338 series MCU, the WAIT signal pins can be selected by the register setting. To
trace the WAIT signals in the E6000 emulator, select the WAIT signal pins by setting switch P4
on the user system interface cable as shown in table 3.
Table 3 Switch P4 Setting
WAITPS Bit Value Pin No. P4 Setting
0
(Initial value) 4 Close between 3 and 4
(setting at shipment)
1 108 Close between 1 and 2