Radio Shack RT-551 - Manual (Page 7)

7
2. Insert the supplied power
adapter’s barrel plug into the DC
12V jack on the back of the base.
3. Route the modular cord through
the groove on the bottom of the
base and the adapter cord
through the strain relief slot on top
of the base.
4. Plug the adapter into a standard
AC outlet.
5. Plug the short modular cord’s
other end into the wall plate jack,
then align the base’s keyhole slots
with the wall plate studs and slide
the base downward to secure it.
6. Fully extend the base’s antenna
and place it in a vertical position.
T P DC 12V LINE
Groove
Strain Relief Slot
LINE
RINGER
OFF
ON
43-1051.fm Page 7 Tuesday, August 17, 1999 1:08 PM