Radio Shack RT-551 - Manual (Page 6)

6
Placing the Base
on a Desk Top
Follow these steps when you place
the base on a desk, shelf, or table.
1. Plug one end of the supplied long
modular cord into the LINE jack on
the back of the base.
2. Insert the supplied power
adapter’s barrel plug into the DC
12V jack on the back of the base.
3. Route the adapter’s cord through
the strain relief slot on top of the
base.
T P DC 12V LINE
T P DC 12V LINE
Strain Relief Slot
4. Plug the adapter into a standard
AC outlet.
5. Plug the modular cord’s other end
into a modular phone line jack.
6. Fully extend the base’s antenna
and place it in a vertical position.
Mounting the Base
on a Wall Plate
1. Plug one end of the supplied short
modular cord into the LINE jack on
the back of the base.
T P DC 12V LINE
43-1051.fm Page 6 Tuesday, August 17, 1999 1:08 PM