Roberts Radio CRD-37 User Manual

Page 6

Using the clock radio for the ﬁ rst time

1. Place your clock radio on a ﬂ at surface.

2. Fully extend the wire aerial located on the rear of your clock radio. The

wire should be fully extended and positioned for optimum reception.

3. Insert the adaptor plug into the DC socket located on the rear of your

clock radio.

4. Plug the adaptor into a standard 13amp mains socket outlet.

IMPORTANT: The mains adaptor is used as the means of connecting
the clock radio to the mains supply. The mains socket used for the clock
radio must remain accessible during normal use. In order to disconnect
the clock radio from the mains completely, the mains adaptor should
be removed from the mains socket outlet completely.

5. When your clock radio is ﬁ rst switched on the display will show "Setting

Clock" and a station search will be performed automatically.

6. When stations have been found, the clock information will appear on

the display. Press the Display button to toggle between showing the
time only or showing both the date and time.

7. If no stations have been found "Clock not set" will be displayed. It may

then be necessary to relocate your clock radio to a position giving better
reception. You should then carry out an autoscan to ﬁ nd stations as
described on page 9.