Radio Shack ET-469 - Manual (Page 15)

15
2. Press HOLD to put the first call on
hold.
3. Press either LINE 1 or LINE 2 for the
line not in use, then place a call to
another party.
4. After the second party answers,
press CONF . This connects all three
parties.
Note: To talk on only one line with-
out disconnecting the other line,
press
HOLD . Both lines’ red indica-
tors flash. Then, press the button for
the line you want to talk on. To
return to the three-way conversa-
tion, press
CONF .
5. To end the conference call with both
lines, hang up the handset.
To disconnect one line and continue
talking on the other, press either
LINE 1 or LINE 2 .
USING TONE SERVICES
ON A PULSE LINE
Some special services, such as bank-
by-phone, require tone signals. If you
have pulse service, you can still use
these special tone services by following
these steps.
1. Set T / P (Tone/Pause) at the back of
the base to P .
2. Dial the service’s main number.
3. When the service answers, press
. Any additional numbers you dial
are sent as tone signals.
4. After you complete the call, hang
up. The phone automatically resets
to the pulse mode.
43-469.fm Page 15 Tuesday, January 19, 1999 9:48 AM