Radio Shack ET-469 - Manual (Page 10)

10
PREPARATION
LINE STATUS
INDICATORS
The Line Status Indicators show you
which line is in use or on hold. If a line is
on hold, the indicator light flashes. If a
line is in use, the indicator lights.
Adjusting the Line Status
Indicators
Each line status indicator is preset to
work correctly with most telephone lines.
However, if an indicator does not light
when its line is in use, you may need to
adjust the indicator to ensure correct op-
eration.
Follow these steps to test and adjust the
Line Status Indicators.
1. Press LINE 1 then lift the handset.
The LINE 1 indicator should light
steadily.
2. Press HOLD . The indicator should
flash slowly.
3. If the indicator worked correctly, it
does not need adjustment. Other-
wise, proceed to Step 4.
4. Slide the phone’s name and number
index card and plastic cover out of
its slot and remove it. Locate the
L1
control.
5. Press HOLD and insert the supplied
flat-blade screwdriver into the indi-
cator control slot and turn in either
direction until the line indicator
flashes slowly.
6. Press LINE 1 . If the indicator flashes
slowly, turn the L1 control until the
indicator lights steadily.
7. Press HOLD again and repeat Steps
4 and 5 until the indicator works cor-
rectly with the line on and off hold.
Repeat these steps to adjust L2 .
Indicator is: Line is:
Off Not in use
On Steadily In use
Flashing rapidly Ringing
Flashing slowly On hold
43-469.fm Page 10 Tuesday, January 19, 1999 9:48 AM