Radio Shack XL-150 - Manual (Page 7)

7
Follow these steps to connect the am-
plifier to ground, switched power, and
primary power.
1. If you have not done so already,
disconnect the cable from your
vehicle’s negative (–) battery ter-
minal.
2. Use a screwdriver to connect the
spade end of the supplied black
ground wire to the amplifier’s
GND
(ground) terminal.
3. Connect the black ground wire’s
other end to a chassis ground,
such as a metal bolt attached to a
metal part of the vehicle’s frame.
Be sure the bolt is not insulated
from the chassis by a plastic part.
4. Use a screwdriver to connect the
spade end of the supplied blue/
white wire to the amplifier’s
REM
(remote power) terminal.
CONNECTING GROUND AND
SWITCHED/PRIMARY POWER
12-2015.fm Page 7 Tuesday, July 13, 1999 3:47 PM