Radio Shack ET-547 - Manual (Page 8)

8
7. Align the base’s keyhole slots with
the wall plate studs and slide the
base downward to secure it.
8. Press and lift out the handset
holder, rotate it 180°, then snap it
back into place so it holds the
handset.
9. Fully extend the base’s antenna
and place it in a vertical position.
Mounting the Base Directly
on the Wall
For this mounting method, you need
two wood screws (not supplied) with
heads that fit into the keyhole slots on
the bottom of the base.
1. Drill two holes 3 15 /
16
inches apart. Then
thread a screw into
each hole, letting the
heads extend about
1 /
5
inch from the wall.
2. Plug one end of the supplied mod-
ular cord into the TEL. LINE jack
on the back of the base.
3. Route the modular cord through
the groove on the bottom of the
base.
4. Plug the cord’s other end into a
modular phone line jack.
5. Insert the supplied AC adapter’s
barrel plug into the DC IN 9V jack
on the back of the base.
3 15 / 15 ”
1 / 5 ”
43-1047.fm Page 8 Tuesday, August 17, 1999 11:37 AM