Radio Shack ET-547 - Manual (Page 15)

15
PAGING
To page the person who has the hand-
set or to locate the handset when the
phone is not in use, press
PAGE on the
base. The handset beeps five times.
Note: The handset does not beep
when the ringer is off.
MEMORY DIALING
This phone has three priority dialing
memories. You can dial a number
stored in any of these memories by
pressing a single button. In addition,
you can store up to 10 telephone num-
bers in speed-dial memory, then dial a
stored number by pressing a one-digit
memory-location number.
Note: Each number you store can be
up to 16 digits long.
Storing a Number in Memory
Note: An error tone sounds and the
phone exits the programming mode if
you wait more than 20 seconds be-
tween each keypress.
1. Lift the handset and press MEMO .
The TALK/BATT LOW indicator
blinks.
2. Enter the number and any TONE
and PAUSE entries. See “Storing a
Tone Entry on a Pulse Line” and
“Entering a Pause.”
Note: Each TONE or PAUSE entry
uses one digit of memory.
3. If you want to store the number in
priority dialing memory, press
MEMO , then press a priority dial-
ing button ( P1 - P3 ).
If you want to store the number in
a speed-dial memory, press
MEMO , then enter the memory
location number ( 0 - 9 ).
A tone sounds to indicate that the
number is stored.
4. To store more numbers, repeat
Steps 1-3.
43-1047.fm Page 15 Tuesday, August 17, 1999 11:37 AM