Runco CL-810 - Manual (Page 51)

51 Runco CL-810 Owner’s Operating Manual
RS-232 Setup
Connecting RS-232 to the
Projector
1. Connect a D-Sub 9-pin female-to-RJ-11 adapter (not included) to a COM port
on your PC. The adapter must be wired as follows:
RS-232 Pin Assignments
D-Sub 9-pin female 4-pin RJ-11 Function
2 2 Transmit Data
3 3 Receive Data
5 1, 4 Ground
1, 4, 6, 7, 8, 9 -- Not Connected
2. Connect the COM port to the RS-232 port on the projector. Use a standard,
4-wire RJ-11 telephone cable, wired straight-through.
1 2 3 4 5
7 8 9 6
D-Sub 9-pin female
RJ-11 to D-Sub 9-pin (not included)
1
2
3
4
Yellow
Yellow
Red
Red
Black
Green Green
Black
3. Start a terminal session on your PC using a terminal-emulation program, such
as HyperTerminal.
4. Configure the COM port on the PC as follows: no parity, 8 data bits, 1 stop bit
and no flow control. Set the baud rate to match that of the projector (115200,
38400 or 9600).
5. Press Enter. You should see a command prompt (>) in the terminal window.
6. Type the desired command from the table that follows and press Enter. For
example, to set the aspect ratio to Letterbox, type x063x .