Runco CL-810 - Manual (Page 43)

43 Runco CL-810 Owner’s Operating Manual
➤
Fan Control
Fan Control
Mode
Fan Speed
Set Up
White Balance
Gamma Selection
SD Enhance
RVR Adjust
Image Over Scan
Image Shift
Amplitude Adjust
Video Black Level
Lamp Power
Remote Control
Reset Lamp Timer
Fan Control
Return to User OSD
Fan Control
> Auto Normal
Auto Hi. Altitude
Manual
Fan Speed
+2
On-Screen Display Menus
Select Fan Control from the Set Up Menu to control the
operation of the projector’s cooling fan.
Mode: In most cases, the default Fan Control Mode (Auto
Normal) will maintain the correct operating temperature. If
the lamp frequently turns off due to overheating, or in certain
high-altitude operating environments, you may need to change
this setting to
Auto Hi. Altitude or Manual.
Fan Speed: If you set the Fan Mode to Manual, select
Fan Speed and use the on-screen slidebar to adjust the
speed.
After changing either of these settings, press
Exit to return
to the previous menu.
To exit the Set Up menu, use the up- or down-arrow keys to
highlight
Return to User OSD and press Enter.
To return to the Set Up menu, select it from the Main Menu,
press
Enter twice, then press MENU on the remote control.
(You do not need to re-enter the passcode.)
➤
Return to User OSD