Radio Shack ET-554 - Manual (Page 16)

16
5. After you complete the call, return
the handset to the cradle or press
TALK . The phone automatically
resets to the pulse mode.
PAGING
To page the person who has the handset
or to locate the handset when the phone
is not in use, hold down
PAGE on the
base for at least 2 seconds. The handset
beeps for 1 minute.
For a brief page, press and release
PAGE/FIND on the base. The handset
beeps five times. To stop it from beeping
sooner, press
TALK .
MEMORY DIALING
You can store up to 10 numbers in mem-
ory, then dial a stored number by press-
ing a one-digit memory location number.
Each number you store can be up to 16
digits long.
Storing a Number in Memory
Note: An error tone sounds and the
phone exits the storing mode if you wait
more than 20 seconds between each key
press.
1. Lift the handset. If you hear a dial
tone, press TALK to turn it off.
2. Press MEM . The TALK/BATT LOW
indicator blinks.
3. Enter the number and any TONE
and PAUSE entries. (See “Entering a
Pause” on Page 17).
Note: Each TONE or PAUSE entry
uses one digit of memory.
4. Press MEM , then enter the memory
location number ( 0 – 9 ). A single tone
sounds to indicate that the number
is stored.
Note: If you make an entry error,
such as entering more than 16 dig-
its, five quick beeps sound, the
TALK/BATT LOW indicator stops
flashing, and the number is not
stored. Start again from Step 2.
43-1053.fm Page 16 Tuesday, August 17, 1999 1:26 PM