Overscan, Memory presets, Information – Runco VP-5000VHDa User Manual
Page 53: Iminar, Pre l iminar y
Vidikron PlasmaView VHD Installation/Operation Manual
41
PRE
L
IMINAR
Y
Overscan: Image Overscan pushes the outside edge of the active picture area of the video
signal out beyond the edge of the display area.
Some television programs are produced based on the assumption that older television sets
may not display the outer edges of the broadcast picture area. Over scan effectively trims
away these inactive, outer edges and enlarges the remaining portion of the image to fill the
display area.
Select from 1% to 10% of Overscan, as desired.
For HDTV, DVDs and other video sources, Overscan is generally not necessary or desirable.
For each input, the PlasmaView VHD lets you save image quality settings as presets that you
can recall at a later time. You can create up to four presets per input and resolution. Use the
Memory Presets menu to recall saved image presets, or to save image settings in the
“Custom 1” or “THX” (“Custom 2” on some models) memory location. The currently-selected
preset is indicated by a “
7
” to its left; in the example shown here, ISF Night is selected.
You should save changes to any of the following settings to a preset; otherwise they will be
lost when a new input source or resolution is selected:
• Brightness
• Contrast
• Color saturation
• Tint
• Sharpness
To reset the Custom 1 and THX (Custom 2) image presets to their factory defaults, select
Factory Default and press ENTER.
Select Information from the Main Menu to see information that uniquely identifies your
display: its serial number, the installed hardware and firmware versions and the firmware
version build date. Should you ever need to contact Vidikron Technical Support, this
information will help them answer your questions or resolve product performance issues.
7
ISF Night
ISF Day
Custom 1 Save
THX (Custom 2) Save
Factory Default
Serial Number
Hardware
0
Firmware
0100.0722
Date
Dec 27 2007