4 operation, 1 turning on the power, 2 setting the computer display properties – Runco VP-5000VHDa User Manual
Page 43: Operation, Turning on the power, Setting the computer display properties, Iminar, Pre l iminar y
Vidikron PlasmaView VHD Installation/Operation Manual
31
PRE
L
IMINAR
Y
4.1
Turning on the Power
1.
Turn on your source components.
2.
Press the main power switch at the front of the PlasmaView VHD (see Figure 2-1). The
standby/on indicator lights green.
3.
Set the main power switch at the rear of the VHD Controller (see Figure 2-4) to the “on”
position.
4.
Press the ON button on the remote control to turn
on the VHD Controller and PlasmaView VHD (or
press the power button on the front of the VHD
Controller). The power indicator on the VHD
Controller lights solid blue.
5.
After a brief warm-up period (approximately 10
seconds), the PlasmaView VHD will display an
image.
4.2
Setting the Computer
Display Properties
To maximize image quality when using the PlasmaView VHD with a personal computer, you
may need to adjust the display properties of your computer’s video card. To do this on a
Microsoft® Windows®-based PC:
1.
Choose Settings from the Windows Start
Menu and click on “Control Panel.”
4
Operation
LIGHT
OFF
ON