RocketFish ROCKETBOOST RF-RBWS02-01 - Manual (Page 20)

20
4 Press the SOURCE button on the second wireless speaker to select the
same Rocketboost audio source as the other wireless speaker. You will
now have two mono speakers, indicated by the LED on the front panel of
each device.
5 Select which wireless speaker you want to be the left speaker, then press
and hold the Source button for five seconds. It will start blinking rapidly.
6 On the other wireless speaker, press and hold the Source button for five
seconds. The Source indicator will blink rapidly and then turn solid. The
Channel (L/R) indicators will then show the appropriate Left and Right
indication for each speaker.
7 The wireless speaker automatically switches to Mono if only one wireless
speaker is turned on; however when the second wireless speaker is
turned on, the stereo settings will take effect.
To adjust the balance of two wireless outdoor speakers:
• If you have two wireless outdoor speakers, you can set the balance of the
left and right speakers. Press the Bass Boost button on the wireless
speaker you want to change, then adjust the volume with the volume
control.
• To reset the left and right speakers to the same level, press and hold the
Bass Boost button for five seconds.
Note: When wireless speakers are connected as a stereo pair, changing the volume
on either unit will cause the volume to change on both wireless speakers, because
they are a stereo pair. If the balance has been set, the offset between left and right
will be maintained during volume level changes.
Turning off the system
To turn off the system:
1 Press on the wireless sender to turn off the unit.
• The power indicator turns off and the standby indicator lights red.
• Remove the AC power adapter from the AC power outlet to power off
the device completely.
2 Press to turn off the wireless speaker. The power indicator goes off.
Notes:
- If there are other wireless senders and wireless receivers in the network, you must
keep your Hub powered on. The hub can be in standby, but it needs to be connected
to the AC adapter.
- The device has its own memory. After the wireless sender/receiver and wireless
speaker are paired once, they will remember each other and join automatically when
the wireless sender/receiver and the wireless speaker are powered on again.
RF-RBWSO2-01_11-0480 _MAN_V1.fm Page 20 Tuesday, May 24, 2011 3:42 PM