RocketFish ROCKETBOOST RF-RBWS02-01 - Manual (Page 16)

16
Establishing communication
Rocketboost products form an audio network and each Rocketboost
receiver can select the audio from any Rocketboost sender in the
network.
Important
Every Rocketboost network must contain one hub device, which
helps devices join the network. The network can have only one hub,
which you can enable using the hub switch on the back of all
Rocketboost senders and wireless sender/receivers.
The RF-RBWS02-01 is a receiver and is not a hub device. To add this
receiver to your Rocketboost network, you need to join it to your hub
device.
Important : Hub devices must always have power for your network to operate. The hub
device can be in standby (power saving) mode, but must stay plugged in.
To establish communications:
1 If possible, bring your Rocketboost hub device and the new Rocketboost
wireless speaker into the same room.
2 Press the Power button on the Rocketboost hub device to turn it on.
3 Press the button on your Rocketboost wireless speaker to turn it on.
4 Press and hold the Power button on the Rocketboost hub device for
more than three seconds to put it into joining mode. The power
indicator starts blinking rapidly and the unit will stay in joining mode for
30 seconds.
5 Press and hold the on your Rocketboost wireless speaker for more
than three seconds to put it into joining mode.
• When successfully joined, the power indicator LEDs on both products
will stop blinking and stay on.
• If joining fails after 30 seconds, the power indicator LEDs will begin
flashing at a slower rate. If this occurs, repeat the above steps.
RF-RBWSO2-01_11-0480 _MAN_V1.fm Page 16 Tuesday, May 24, 2011 3:42 PM