Renesas M16C/26A - Manual (Page 14)

• Place a breakpoint at the call to main();
Breakpoints can only be set when the E8a is connected to the target and the module is downloaded. Breakpoints can be
set by double clicking in the column containing the PC arrow next to the line to break at; or selecting the line and pressing
; or right click on the line and select ‘Toggle breakpoint’. Alternatively set an eventpoint, by clicking in the column to the
left of the breakpoint column. Up to 6 eventpoints can be set. Eventpoints do not require programming the flash memory,
and thus are faster to use.
• Press ‘Reset Go’ on the Debug Tool Bar.
The code will execute to the breakpoint. At this point all the device initialisation will have been completed.
• Press ‘Step In’ on the Debug Tool Bar.
The code window will open ‘main.c’ and show the new position of the program counter.
• Insert a breakpoint on the call to the TimerADC
function.
10