RCA F20TF10 - Manual (Page 48)

Using the TV’s Menu System
46 Chapter 4
Tip
Feel free to explore the menu system. If you’re
ever unsure where you are in the menu system,
or you’re just plain tired of exploring, press
CLEAR to remove the menus from the screen and
start over again.
How to Use Your TV’s Menu System
You use the buttons on the remote or the front of your TV to access the menu system and make changes to the settings.
The following pages explain how to use the different types of menus to adjust the features of your TV.
TV MAIN MENU
1 Audio
2 Picture Quality
3 Screen
4 Channel
5 Time
6 Parental Controls
7 GUIDE Plus+ Menu
8 Setup
0 Exit
TV MAIN MENU
1 Audio
2 Picture Quality
3 Screen
4 Channel
5 Time
6 Parental Controls
7 GUIDE Plus+ Menu
8 Setup
0 Exit AUDIO
1 Tone Controls
2 Audio Processor
3 Speakers
0 Exit
Menus
The first menu is called the Main menu. Press MENU on
the remote or on the front panel to bring up the Main
menu. Note that holding MENU for 2 seconds displays
the GUIDE Plus+ system.
Menus take you to another menu or a control panel.
There are two ways to select a choice in a menu:
• Use your arrow buttons on your remote control to
highlight your choice, and press OK.
• Press a number button on the remote. For example,
in the Main menu press 3 to go straight to the Screen
menu.
Exiting a menu
There are three ways to exit a menu:
• Highlight Exit and press OK.
• Press 0 on the remote.
• Press CLEAR. The on-screen displays are cleared from
the screen and you return to TV viewing.
Audio Menu
Tone Controls Displays the slider controls for adjusting
the TV’s treble, bass and balance.
Audio Processor Displays a choice list of available
audio modes, which control the way the sound comes
through your speakers. You can also access the AUDIO
PROCESSOR menu by pressing the SOUND button on the
remote.
Mono Plays the sound in mono only. Use this
setting when receiving broadcasts with weak stereo
signals.
Stereo Splits the incoming stereo audio signal into
left and right channels. Most TV programs and
recorded materials have stereo audio. The word
STEREO appears on the TV when you tune to a
program that is broadcast in stereo.
Sound Logic ™ Stereo Reduces the annoying blasts
in volume during commercial breaks, and also
amplifies softer sounds in program material.
Eliminates the need to constantly adjust volume
control.
1569452A.04 Menu 4/9/02, 12:57 PM 46