RoyalTek RTW-1000 - Manual (Page 24)

~ 24 ~
RTW-1000 Operational Manual
Ø The GPS receiver does not start automatically.
Solution:
GPS cannot be initialized even after the configuration of the COM1
port,
1.
Close the navigation program.
Check the GPS reception settings under Start – Settings – System –
GPS
. It is recommended to use the automatic start when
accessing COM1. Restart the navigation program.
The display jitters / slows down, responds sluggish or the program
aborts.
This may be due to reduced memory availability. Normally, The
navigation software requires approximately 10-15 MB of free main
memory (for swapping-out files, etc.). If this is no longer available,
the stated problems may arise. The Pocket PC may also go into
energy-saving mode, which can lead to the memory card no longer
be recognized correctly.
Solution:
Ø Close down all programs.
Ø Delete unnecessary files (MP3, PDF etc.) or save them
externally.
Ø Start the navigation program again.
Ø Carry out a soft-reset (see page 16).