Radio Shack ET-1105 - Manual (Page 7)

7
3. Insert the supplied AC adapter’s
barrel plug into the DC 9V jack on
the back of the base.
4. Route the adapter’s cord through
the strain relief slot on the bottom of
the base.
5. Insert the tabs on the narrow end of
the bracket into both upper slots on
the bottom of the base as shown
and push the tabs on the wide end
of the bracket into the upper slots on
the bottom of the base.
6. Plug the modular cord’s other end
into a modular phone line jack.
7. Plug the adapter into a standard AC
outlet.
8. Raise the base’s antenna to a verti-
cal position.
43-1105.fm Page 7 Monday, August 30, 1999 1:57 PM