ROTEL RB-03 - Manual (Page 8)

8 RB-03 Stereo Power Amplifier
Troubleshooting
Most difficulties in audio systems are the re-
sult of poor or wrong connections, or improper
control settings. If you encounter problems,
isolate the area of the difficulty, check the con-
trol settings, determine the cause of the fault
and make the necessary changes. If you are
unable to get sound from the RB-03, refer to
the suggestions for the following conditions:
Front Panel Power Indicator Is
Not Lit
No main power to the RB-03. Check the front
panel power switch. Make sure that it is set
to the on position. Check AC power connec-
tions at the amplifier and the AC outlet.
Fuse Replacement
If everything checks out correctly and you still
cannot get the amplifier to turn on, the inter-
nal power fuse may have blown. If you be-
lieve this has happened, contact your autho-
rized Rotel dealer for information on where
to take your amplifier to get the fuse replaced.
No Sound
If the amp is getting AC power, but is producing
no sound, check all of your connections and
control settings on associated components.
Specifications
Continuous Power Output 70 watts/ch
(20-20 kHz, < 0.03%, 8 ohms)
Bridged Mono Power Output 180 watts
(20-20 kHz, < 0.1%, 4 ohms) (200 watts at 1kHz)
Total Harmonic Distortion (20Hz-20kHz, 8 ohms) < 0.03%
Intermodulation Distortion (60 Hz : 7 kHz, 4:1) < 0.03%
Frequency Response ( ± 1dB) 10Hz-100kHz
Damping Factor (20-20,000 Hz, 8 ohms) 500
Speaker Impedance (Normal mode) 4 ohms minimum
Signal to Noise Ratio (IHF A network) 116 dB
Input Impedance/Sensitivity 33 k Ohms/1.0 volt
Power Requirements
USA Version 115 Volts, 60 Hz
European Version 230 Volts, 50 Hz
Power Consumption 250 Watts
Dimensions (W x H x D) 435 x 92 x 334 mm
17 1 / 8 x 3 5 / 8 x 13 3 / 16 ins.
Panel Height 80 mm / 2 5 / 32 "
Weight (net) 7.5 kg, 16.54 lb.
All specifications are accurate at the time of printing.
Rotel reserves the right to make improvements without notice.