Radio Shack DX-392 - Manual (Page 12)

12
Memory Tuning
For easy selection, you can store the
frequencies of your favorite stations in
memory. You can store up to 18 SW
and 18 FM frequencies, and up to 9
frequencies in each of the other bands.
Follow these steps to store a frequen-
cy into memory.
1. Use direct-access or manual tun-
ing to tune to the frequency you
want to store.
2. Press M .
3. While M flashes, enter a memory
location code using the numeric
keypad. For SW and FM bands,
select from 1–9 and 01–09. For
other bands, select from 1–9. The
frequency is stored,
M stops flash-
ing, and the display shows the
memory location code
Note: If you wait more than 15 sec-
onds to press a memory location code
number,
M stops flashing and you must
begin again at Step 2.
To select a stored frequency, press
FM , MW , LW , or SW to select the band.
Then enter the memory location code.
ADJUSTING THE
ANTENNA
For the best reception, adjust the tele-
scoping antenna for the band you want
to listen to.
FM — Fully extend the antenna and
rotate it for the best reception.
LW and MW (AM) — Rotate the re-
ceiver. The receiver uses the internal
antenna for the LW and MW (AM)
bands.
20-219.fm Page 12 Wednesday, August 4, 1999 9:23 AM