RIDGID RIGID OF25135A - Manual (Page 13)

XXXXXXX
Apprendre à connaître
votre compresseur d’air
2 Manomètre Réglé
de Sortie d’Air
5 Manomètre
du Réservoir
4 Bouton de
Régulateur
1 Réservoirs de
stockage d’air
3 Poignée
7 Raccords de
sortie d’air
6 Soupape
de Sûreté
ASME
9 Interrupteur Marche/Arrêt
10 Robinet de vidange
du réservoir
1. Read instructions: Carefully read
through this operator’s manual
BEFORE OPERATING the new air
compressor. It contains information
about operation and maintenance of
the unit.
2. Drain tank daily: Depressurize system
prior to draining tank. Open tank
drain valve and drain moisture from
tank. This helps keep oil and mois-
ture out of the compressed air sys-
tem. Be sure to close tank drain valve
tightly before operating compressor.
Operating Your Air Compressor
Fr 12 13
Moisture in compressed air will form into
droplets as it comes from an air com-
pressor pump. When humidity is high or
when a compressor is in continuous use
for an extended period of time, this mois-
ture will collect in the tank. When using a
paint spray or sandblast gun, this water
will be carried from the tank through the
hose, and out of the gun as droplets
mixed with the spray material. IMPORTANT : This condensation will
cause water spots in a paint job, espe-
cially when spraying other than water
based paints. If sandblasting, it will
cause the sand to cake and clog the gun,
rendering it ineffective.
A filter in the air line, located as near to
the gun as possible, will help eliminate
this moisture.
For Trouble-Free Operation
Moisture in Compressed Air
Make sure the tank drain valve is closed,
the regulator knob is turned fully counter-
clockwise, and the On/Off switch is in the
OFF position.
Plug compressor into a dedicated 15
Amp (minimum) circuit.
Turn On/Off switch to the ON position.
The compressor will now start building
pressure.
After compressor reaches cut-off pres-
sure, install a hose (with the desired air
tool attached) into the outlet fitting. Adjust the regulator knob to the desired
pressure.
The compressor is now ready to operate.
Do not over-pressurize any air
tool. Consult air tool instruc-
tions for proper air tool pres-
sure.
! WARNING:
ridgid.com 1-800-474-3443
Operating Your Air Compressor
Décalque de modèle
8 Compresseur